The short answer
If a pipe freezes, turn off the water at the stop tap and open the nearest tap. Thaw the pipe slowly with hot water bottles or warm towels. Never use a naked flame or a blowtorch. Check for leaks as the ice melts, because a split pipe may leak then.
The advice to use the stop tap, open a nearby cold tap, thaw the pipe slowly and avoid naked flames follows the Met Office guidance on frozen or burst pipes. The other steps are general good practice.
Signs of a frozen pipe
A frozen pipe often shows itself in a simple way. You turn on a tap, and little or nothing comes out. The kitchen cold tap is a common place to notice it, since the pipe may run along an outside wall.
Other clues include a pipe covered in frost and a boiler that has stopped working. A frozen pipe is not yet a burst, but ice can split a pipe as it melts. So act early, because the thaw is when leaks show.
How to thaw it safely
Work slowly, and keep the water off while you do, because a hidden crack can leak as soon as the ice melts.
- Turn off the water at the stop tap.
- Open the nearest cold tap so melting water has a way out.
- Warm the pipe gently, starting nearest the tap and working back. Use hot water bottles or towels soaked in hot water.
- Check for leaks as the pipe thaws, and look along the whole run.
- Turn the water back on slowly once the flow returns, and watch the joints.
If you cannot find the frozen section, or you cannot reach it, ask a plumber to help. Our guide to where your stop tap is likely to be helps if you are not sure where to start.
What never to use
Never use a naked flame or a blowtorch. A flame can set fire to a building, while it can also damage the pipe or its joints. Gentle warmth and patience work best, because heat applied too fast can crack a weak pipe.
If a pipe has burst
Water pouring from a pipe means a burst. Turn off the water at the stop tap straight away. Switch off the boiler and the heating, and open the taps to drain the system. Keep away from electrics near the leak.
Our guide to the first 10 minutes of a plumbing emergency covers each step. Read the signs of a burst pipe if you suspect a slow leak. TradeMatch puts a burst pipe repair at about £150 to £400. Our burst pipe repair page explains the service.
Protect your pipes before winter
A few simple steps lower the risk, although none removes it.
- Insulate pipes in lofts, garages and outbuildings.
- Find your stop tap now, and test it. The Met Office advises testing it every six months.
- Fix dripping taps and overflows, since they can freeze.
- Know who to ask for help before you need it.
If you plan to leave a home empty, tell someone who can check it, because a leak in an empty house can run for days before anyone notices.
What else can freeze
Boilers can stop when pipes freeze. If your heating dies in a cold snap, read boiler fault codes and check for a frozen section. If you have heat but no hot water, see no hot water: what to check.
Outside, gullies can freeze or overflow. Our guide to a blocked drain outside the house covers the checks. Gas appliances also need care in cold weather, and our guide to carbon monoxide at home explains the signs of a fault.
Cost and choice
Out-of-hours help often costs more than daytime work. Our guide to what an emergency plumber costs shows the typical ranges from two sources. Before you book, read how to choose a plumber for the checks to make.
Frequently asked questions
Will a frozen pipe always burst?
No. Many thaw without splitting. However, ice can crack a pipe, so check for leaks as it melts.
Should I leave the heating on?
Heating helps keep pipes above freezing. However, if a pipe has burst, switch the boiler off until a plumber checks the system.
What should I use to thaw a pipe?
The Met Office suggests hot water bottles or towels soaked in hot water, applied gradually. Keep the stop tap off and a nearby cold tap open.
Ask for help
Our emergency plumber service and burst pipe service take requests through the online form at any hour. Mark it urgent if water is escaping. Browse all our services or the areas we cover. Add your town and a short description, because that helps an engineer get back to you.
In Northampton, see emergency plumbers in Northampton. Around Brackley, see plumbers in Brackley. In Market Harborough, see plumbers in Market Harborough. Near Daventry, see plumbers in Daventry. These pages list local details, since coverage varies from town to town.
We cover Northampton and a 30-mile radius, while the request form is open 24/7. Our engineers are Gas Safe registered.
Last updated 5 November 2026
Related Services
Burst Pipes & Leak Detection
Burst pipe repair and leak finding across Northampton and towns within 30 miles. Turn off the stop tap first, then send an urgent request while you mop up.
Learn more →Emergency Plumber
Help for burst pipes, bad leaks and heating failures across Northampton and towns within 30 miles. The request form is open 24/7, so you can send details while the problem is fresh.
Learn more →